Honda Pacific Coast ipcrc Archives

Title and Body Title Only	All Words Any Word Phrase
Author:
Search Start Date:
Search End Date:
Sort Order	Newest Posts First Oldest Posts First
Sources to include:	Both Yahoo Groups and List Server Only Yahoo Groups Only Older List Server
OR Message ID:

HELP!! No clutch
Written by divein_southfl on 6/8/2011 at 05:04 pm

Thanks Wade- It worked and I'm back on the road. YEE-HAW!

--- In ipcrc@yahoogroups.com, "Wade" <wbpc800@...> wrote:
>
> Mike,
>
> If you are lucky, you might get by with a simple fix. Right above the clutch
lever is a reservoir that holds brake fluid to drive the clutch. I am pretty
sure if you look through the sight glass on it, you will see that it is low or
empty.
>
> Cover your plastic first. Brake fluid will harm any paint it touches.
>
> Use a Phillips screwdriver to remove the 2 screws holding the cover and
carefully lift off the cover and set it someplace clean. You don't want to
contaminate they system.
>
> On the cover I believe it specifies DOT 4 brake fluid. That is what my 96
calls for. From a new bottle of it, fill the reservoir to the full line.
Carefully replace the cover and pump the clutch until hopefully it starts
working.
>
> You may get by with this and you may get by for quite some time. However,
there is a reason why the fluid is gone. Unless you are really incredibly lucky
and the new fluid swells the seal that was leaking and you just happened to get
the air out of it, you will likely have to deal with the slave cylinder. Not
sure someone with no mechanical ability would want to tackle that. I haven't
done it yet on a PC so I don't have any idea how difficult or easy it is to get
at and rebuild.
>
> If you do get it working again by just topping off the fluid, keep a close eye
on the sight glass so you can see how fast it is leaking. Don't let the fluid
get below the low mark. If you have to add again soon, you probably should take
it to a mechanic and get it fixed.
>
> Wade
>
>
>
> --- In ipcrc@yahoogroups.com, "Mike" <divein_southfl@> wrote:
> >
> > Well I have put about 600 miles on my just purchased '90 PC so now, with
only 10,100 total miles my cluth is gone. Was taking it out for a spin and when
I squeezed the clutch control and dropped it from neutral to 1st it bucked and
died. Tries again, same result. It doesn't have the same resistance when I
squeeze it, actually feels like none at all, so do I assume it is the clutch
cable? I looked thru the archived files and found clutch R&R but no mention of
cable. I have the mechanical ability of the average housewife (no offense
ladies!) so I need help. PLEASE ADVISE!!!
> >
>