Search Messages

 
Author:
Search Start Date:
Search End Date:
Sort Order
Sources to include:
OR Message ID:
 

Display Mesage #117317


Engine Removal
Written by D on 10/13/2012 at 12:00 am

Just an inquiry. To those of you who have removed and reinstalled a PC engine...is it a lot of work? Does the service manual provide enough info to do this correctly? Any tricks or weird things you came across while doing this?

Message Thread for message #117317

D
10/13/2012, 12:00 am
Engine Removal
Just an inquiry. To those of you who have removed and reinstalled a PC engine...is it a lot of work? Does the service manual provide enough info to do this correctly? Any tricks or weird things you came across while doing this?

    skyeenter
    10/14/2012, 12:00 am
    Re: Engine Removal
    It's a lot of work if you do it by yourself. And it can be dangerous as well. Best to have someone with some strength and know how to assist.Make sure the frame is supported with blocking or jack stands. Do not take anything for grant

    D
    10/14/2012, 12:00 am
    Re: Engine Removal
    Great advice and thanks for the messages info on your extensive writeup. I will read it thoroughly before attempting this. The project will be a winter project so I have lots of time.Don't know how else to contact you but I noticed in a

    glennschechter
    10/14/2012, 12:00 am
    Re: Engine Removal
    Good Info Skye,I actualy was able to pull the engin and completly strip the frame of the PC that I parted out in less then an hour. I did youse an air rachet except on the exhaust flang nuts on the head. There I used an impact gun. I put all hard

    skyeenter
    10/14/2012, 12:00 am
    Re: Engine Removal
    The wiring harness for the 89 only fits the 89. If you compare the wiring diagrams for the 89 w/ the others you'll see the plugs for the stator are different. I believe the 89 has 4 leads on the connector and the other years only have three com

    nusbaum01
    4/29/2015, 12:00 am
    Re: Engine Removal
    Do you happen to know if a 96 engine will fit in a 94 bike?  If you don't know do have any idea where I can check?  Thanks in advance for the reply. Tim

    skyeenter
    4/29/2015, 12:00 am
    Re: Engine Removal
    Tim, a 96 engine into a 94 frame will work.  No problems, everything will match up.   Removal is about an hour to two, replacement is about 4 - 5 hours.   Make sure you keep track of and mark your parts.   Make sure

    nusbaum01
    4/30/2015, 12:00 am
    Re: Engine Removal
    Thank you for the feedback.  The advice is greatly appreciated. The replacement has 24K miles with no signs of any leaks.  I'm dealing with some oil leaks and occasional trans slippage in my current engine.  Interestingly enough it