Honda Pacific Coast ipcrc Archives

Title and Body Title Only	All Words Any Word Phrase
Author:
Search Start Date:
Search End Date:
Sort Order	Newest Posts First Oldest Posts First
Sources to include:	Both Yahoo Groups and List Server Only Yahoo Groups Only Older List Server
OR Message ID:

Choke cable replacement--HELP!
Written by pgboyd on 6/16/2010 at 01:36 pm

When I did mine last month, I already had the top shelter and air cleaner
housing off. The Service Manual section 5-4 shows a good picture. I found it
easier to remove the carb before removing and replacing the choke cable so I
could turn the carb and get a better angle at the nuts that hold the ends of the
choke cable to the carbs.

I can't recall what size wrench end you need - because of the cable it would be
useful to have an open ended wrench or one of those sockets that are used for
oxygen sensors that will go over a cable. There is a small spring on each
connector to the carb so watch for that when you get the nut loosened up. I
don't remember exactly how the cable ends connected, but it was pretty obvious
once you had the old one removed.

Phil
Northern VA

--- In ipcrc@yahoogroups.com, "wewillpraisethelord" <Rkenman44@...> wrote:
>
> Does anyone have instructions on replacing the choke cable. From removal of
plastic to everything to get to the choke cable connection on the carbs.
>
> --- In ipcrc@yahoogroups.com, "pjbt2" <pjbt28@> wrote:
> >
> > Well...I pulled back the small 90 deg. boots and noticed the nuts (holding
the needles & springs in) and figured it out. It only took a few mins. to R&R
the cable after that. Still idling/running rough though. I haven't ridden it
much over the last 4 yrs. since I picked up the GL so I have a few more things
to check out, clean, & possibly change.... I had a spare air filter so I
changed that out while I was at it too.
> > +Peter+
> >
> >
> > --- In ipcrc@yahoogroups.com, "pjbt2" <pjbt28@> wrote:
> > >
> > > I figured this has been posted before but I can't find any directions
online and the Serv. Mnl. I have is no help!
> > > I'm replacing the broken/glued/broken-again choke cable assy on my '96,
but can't seem to remove the old cable. The two cable ends seem to be attached
inside the carb and don't want to force them out. Plus, how do the new ones
attach??
> > >
> > > Thanks in advance for your help!
> > > +Peter+
> > >
> > > Peter J.B. Teague
> > > Plainville, MA
> > >
> >
>