Honda Pacific Coast ipcrc Archives

Title and Body Title Only	All Words Any Word Phrase
Author:
Search Start Date:
Search End Date:
Sort Order	Newest Posts First Oldest Posts First
Sources to include:	Both Yahoo Groups and List Server Only Yahoo Groups Only Older List Server
OR Message ID:

Throttle locks ?
Written by gibinmich on 7/14/2010 at 07:54 pm

Strange, something is not right. I think my adjustment screw is in about four or
five turns. Please don't ask me to check.

--- In ipcrc@yahoogroups.com, "ombestudio" <ombestudio@...> wrote:
>
> Thank you guys for the responses.
>
> I actually cut the tab off the throttle lock and figured I would just drill
into the housing. I never got that far because I can't seem to position it where
it isn't binding. As far as having the screw for the tension to tight,it seems
when it is not too tight it is with only one turn and I'm afraid it will pop
out. I also have enough room between the housing and the grip so it doesn't seem
to rub. I will take another look.
>
> --- In ipcrc@yahoogroups.com, "Gib" <gibinmich@> wrote:
> >
> > Mine was binding up a little because I didn't drill the hole for the tab in
the right location. I went to the hardware and bought a couple of 7/8 inch I.D.
nylon washers and put one on each side to keep it away from the housing and the
grip and now all is well. This is my third Vista and it was the first time I got
the tab hole in the wrong location. If your reading this Tim, yours is drilled
in the right spot.
> >
> > --- In ipcrc@yahoogroups.com, "goldwingman40" <goldwingman@> wrote:
> > >
> > > Orrin,
> > > The bars on the PC are 7/8" at the ends, they are only 1" at the center
where the clamps are.
> > > If the slot for the tab is not cut in the correct location and with a
slight cnearance the unit can't float to canter itself on the throttle tube and
will bind the throttle. Also there is the screw to adjust the tension, do you
have it too tight?
> > > Fred
> > >
> > >
> > >
> > >
> > >
> > > --- In ipcrc@yahoogroups.com, "ombestudio" <ombestudio@> wrote:
> > > >
> > > > Hi guys, I'm kinda new around here and mostly a lurker. I do have a
stupid problem and really need some help... so here goes.
> > > >
> > > > I have an '89 and bought a vista cruise throttle lock like I've done for
all my past motorcycles. I can't get the freakin thing onto the PC though. I
understand about either cutting a slot or drilling a hole to mount it, that
isn't the problem. It seems to be too tight. I guess I have the one for 7/8 bars
but they don't have one for 1" bars except the one with the bar across the
housing. With the single one I have, the throttle is too tight, it doesn't just
release and snap back and you can't even twist the throttle normally. I have
enough room between the housing and grip. I hope I made some sense.
> > > >
> > > > This is so stupid!
> > > >
> > > > Any help is much appreciated.
> > > >
> > > > Orrin
> > > >
> > >
> >
>