How to change antifreeze on the PC800Written by eriviere01 on 7/20/2010 at 11:51 pmThe owners manuel says to drain the fluid at the bottom bolt on the ater
pump.It is located near the left foot peg
From: Jerry
Sent: Tuesday, July 20, 2010 6:29 PM
To:
ipcrc@yahoogroups.comSubject: PC800: Re: How to change antifreeze on the PC800
Just a suggestion since you may end up pulling bodywork off the bike to change
the coolant.
Take a moment to pull the thermostat and check its operation by putting it in a
pan on the stove to verify it opens as it should.
Jerry
--- In
ipcrc@yahoogroups.com, "rj.2000@..." <rj.2000@...> wrote:
>
> Ok, I've searched with no luck, so forgive me if this is discussed elsewhere.
>
> The PC800 user's manual states that you should let a certified Honda mechanic
change your antifreeze. I figure they are crazy. At the hourly rate they charge
these days it might cost you $100 USD to change your antifreeze.
>
> I know all about the different types and I'll be using Prestone DexCool
Extended Life pre-mixed 50/50. What I need help on is where to drain the fluid.
There is a hose at the left side bottom of the radiator that looks like a good
candidate since it seems to be the lowest point on the cycle where antifreeze
circulates. Anybody want to confirm?
>
> Has anybody documented the correct way to change PC800 antifreeze?
>
> Regards,
>
> Rick
>