Search Messages

 
Author:
Search Start Date:
Search End Date:
Sort Order
Sources to include:
OR Message ID:
 

Display Mesage #98038


Doing the hotwire mod and have a question
Written by mfmarkart on 10/18/2010 at 11:03 pm

Could I just use a couple of these and splice above the connector?
http://www.amazon.com/Quick-Splice-Connector-16-14-Gauge/dp/B003L9KWQ4
Seems easier.

--- In ipcrc@yahoogroups.com, "Mark" <mfmarkart@...> wrote:
>
> I have the plug off the R/R and can't figure out how to remove the wires from
the plug. Does the plastic plug split somehow or do I have to force the
terminals from the opposite and wiggle them out? Mark
>

Message Thread for message #98038

mfmarkart
10/18/2010, 10:56 pm
Doing the hotwire mod and have a question
I have the plug off the R/R and can't figure out how to remove the wires from the plug. Does the plastic plug split somehow or do I have to force the terminals from the opposite and wiggle them out? Mark

    mfmarkart
    10/18/2010, 11:03 pm
    Doing the hotwire mod and have a question
    Could I just use a couple of these and splice above the connector? http://www.amazon.com/Quick-Splice-Connector-16-14-Gauge/dp/B003L9KWQ4 Seems easier. -

    Gwynethh
    10/19/2010, 12:22 am
    Doing the hotwire mod and have a question
    To remove the connectors you have to use a VERY small screw driver to relieve a locking clip of the plastic. The little clip/finger is part of the plastic and locks the spade terminal into place. Really easy once you can see/relieve it/them.

    unlikelylogi...
    10/19/2010, 02:23 am
    Doing the hotwire mod and have a question
    Mark, Try holding a bright penlight against the connector. You ought to be able to see where the tab is lurking. Have a look at the top right diagram on this drawing: http://tinyurl.com/2648

      mfmarkart
      10/19/2010, 12:29 pm
      Doing the hotwire mod and have a question
      Thanks all for the advice! Seth, the illustration REALLY helps. I'm planning on working on the mod tonight. My Chinese R/R is at the post office, picking it up tonight. Will complete the mod first and test, then I'll replace the R/R. I'll pos

        mfmarkart
        10/20/2010, 12:32 pm
        Doing the hotwire mod and have a question
        I decided to do the reverse and change out the R/R, go for a ride and get results, then do the mod. Well the new R/R is installed (no mod) and I'm getting some curious results. I now have the dreaded upside down voltage issue to some degree.

          pogomann2002
          10/20/2010, 01:10 pm
          Doing the hotwire mod and have a question
          Hey Mark, Don't confuse your readings with the "dreaded uside down voltage readings) with proper operation. The "dreaded" issue is when it's reading 14 to 15 volts at idle and 12.9 at higher speeds. What you are seeing is the b