Doing the hotwire mod and have a questionWritten by mfmarkart on 10/19/2010 at 12:15 amGot it Fred. What about disassembling the connector? Mark
--- In
ipcrc@yahoogroups.com, "goldwingman40" <goldwingman@...> wrote:
>
> Mark,
> NO!!!!! That is why we need to use the hot wire mod. All the plugs and
connectors have voltage losses. You need a good solder connection to eliminate
the problem of connections oxidizing and increasing resistance which cause a
voltage loss and heating the connection which also increases the resistance and
voltage loss. That is why you find melted connectors.
> Fred
>
>
>
>
>
> --- In
ipcrc@yahoogroups.com, "Mark" <mfmarkart@> wrote:
> >
> > Could I just use a couple of these and splice above the connector?
> >
http://www.amazon.com/Quick-Splice-Connector-16-14-Gauge/dp/B003L9KWQ4> > Seems easier.
> >
> > --- In
ipcrc@yahoogroups.com, "Mark" <mfmarkart@> wrote:
> > >
> > > I have the plug off the R/R and can't figure out how to remove the wires
from the plug. Does the plastic plug split somehow or do I have to force the
terminals from the opposite and wiggle them out? Mark
> > >
> >
>